Connection with Compression fittings                        
UNIFLEX compression fitting charge has been designed to be user-friendly and at the same time keeping its high functionality in mind! Separated structure makes it very convenient for installation and dismounting. Apart from the metal to metal seal, there is an additional O-ring seal between the taper of the insert and the fitting body. The permanent pipe joint is achieved by compression, in fact by tightening the nut against the cone shaped olive, the profiles of the two pipes are designed to cause a progressive shrinkage of the cone olive and to distribute the compression forces across all the contact surface. Also the assembly times are considerably reduced. For jointing, brief procedure is as follows :  Pipe is pushed over the insert. Split ring is pushed until it touches the fitting. Nut is tightened over the fitting.